Deutsch 
With its small, compact design, the Supfina Fact (Fast Action Changing Tool) tape finishing attachment is ideal for use in revolver lathes.
In addition, the surface qualities that can be achieved are much higher than those achieved with standard turning. This means that even the highest surface requirements of your customers will be fulfilled.
| Technical data | Supfina Fact |
| Spring contact force | 22 – 110 N |
| Oscillation frequency | bis ca. 25 Hz |
| Tape width | max. 25 mm |
| Tape roller diameter | max. 68 mm |
| Weight approx. | ca. 11 kg |
| Amplitude | ±1 mm |
Documentation and videos
Further information as PDF
Download
Let’s get to know each other. Continue to download... ×
Get smarter – connect with us
Thanks for your interest in our solutions!Let’s get to know each other. Continue to download... ×
Typical workpieces for this attachment
Simply select the workpiece to be machined or a similar one and receive a customized selection of suitable Supfina attachments.
Quick, easy, and precise.
Cup tappet
The superfinishing of the surface at the cup tappet is very important to ensure optimal performance, durability and reliability of the engine.
Planetary gear
The front face of the planetary gear is finished to ensure precise alignment, minimized imbalance, increased durability, and reduced friction in the planetary gear system.
Pump piston
Supfina equipment can be used to finish the pump piston raceway that is in contact with the cylinder wall. A finely machined raceway ensures good sealing and reduces wear.
Pinion Shaft
The bearing points of the pinion shaft are exposed to particular loads. Therefore, these must be superfinished for a long running time.
Control slide
When using the control slide in hydraulic or pneumatic systems, the sealing surfaces are finished to ensure effective sealing and to obtain precise and smooth switching.
Pump shaft
The bearing points of the pump shaft can be machined with stone or tape finish as required. For lathes, carrier machines or in a turret, Supfina offers a suitable device.
Turbine shaft
The bearing seats of the turbine shaft can be machined with stone or tape finish as required. For lathes, carrier machines or in a turret, Supfina offers a suitable device.
Driveshaft
The bearing seats of the drive shaft are finished to enable precise and low-friction movement of the shaft in the bearing. For both carrier machines, lathes and turret lathes, Supfina offers a suitable attachment here.
Gear shaft
The bearing seats of the gear shaft are finished to allow precise and low-friction movement of the shaft in the bearing. For both carrier machines, lathes and turret lathes, Supfina offers the suitable attachment here.
